Engine ice Hi-performance coolant - tyds008 - engine ice 81081100

Product Information

How can I do to 'induce' the coolsntbin the plastic tank to circulate and flush through the radiator drain cap?

It did yesterday when I got home from a pretty hard ride, not sure if it had been boiling over the whole time or just when I got home and let it idle for a second while I opened my gate. I've got one of those generic PDF service manuals and the printed (book) SE supplement, and I'll be damned if this is not an allen metal bolt, LOL! So, since it is free of phosphates, I am going to eliminate the P-HOAT (which I have in my garage for my V-Strom).Due to X1 being a reformulated vegetable extract the colour of the coolant can vary from clear to straw yellow in colour.

Thanks, what I noticed is apparently all the orange HD coolant and then the water to clean it where drained from the system, but the level in the plastic tank didn't seemed to lower even when there was nothing else pouring from the drain plug. From the "high horsepower in a small package" super pee-wee racing machines to the big bore four-stroke machines famous for churning out massive heat, Engine Ice proved to be the coolant of choice of top racers everywhere. From a performance point of view, ethylene based anti-freeze would be considered as the "better" one but also as the more poisonous one. Drain the old coolant, then fill the bike with strait distilled water until it gets to operating temperature, and then drain, to flush.I think the problem GM was having was not the Dex-Cool (OAT) but the gasketing material / installation procedure. Small amount of residual water remaining from flushing will evaporate after several run cycles but adding water is not advisable. Engine Ice Hi-Performance Coolant TM demonstrates outstanding cooling capabilities and corrosion prevention performance in all government, manufacturer and standard industry tests.

I do not see how it could hurt but I just thought I would ask the org before I put it in next weekend any advice would be appreciated! This way if your cooling system pukes out all the coolant on road or trail any critters that drink or eat it should not die or get sick. The difference in surface tension is on a near microscopic level, while bleeding the cooling system is definitely macroscopic since it's a pocket of air big enough to prevent coolant flow to your heater core. Engine Ice meets or exceeds all relevant ASTM and SAE standards and requirements, and you can use it in virtually any vehicle with a radiator. However, if down the road our engines have to come apart to resolve this, then it's not exactly pointless.This revolutionary *non conductive liquid marvel is a food safe non toxic fluid that is biodegradable and has excellent lubricating and cooling properties. The manufacturer initially looked at off-road motorcycle performance, in a wide range of conditions, and straight out of the bottle it is able to reduce engine operating temperatures! As for the original question, if you are just slightly low, and need to top off, you should be able just to use distilled water if it isn't enough to change the mix ratio much. As an FYI, Peak EOT 50/50 Blue Asian Anti-freeze has a freeze point of -34F to give you some frame of reference. Engine Ice Hi-Performance Coolant is engineered to maintain optimum operating temperature and reduce power loss from excess heat.